User Guide

Connect IDE cable
It would be easier to carry out the procedure if the IDE cable is properly plugged before
locking up the hard disk to the frame. You can distinguish IDE cable from left and right.
Normally, a standard cable has a foolproof device, which is a small salient on the cable,
and a small dent in the socket. Just aim the salient at the dent and then plug it in.
Lock the hard disk in the frame.
Our special design provides you an easy way to remove HDD / FDD frame from the
housing. Just press the spring and pull the frame outward.
What if there is no foolproof device
on the cable?
If you happen to have a cable without foolproof
design, just remember that the first pin is next to the
red line and it would be safe to locate the first pin
close to the power cord
The first pin is close to
the power connector.
2-8
Start To Handle