User manual

Anypos600 Point of Service

A). I

f Windows start the New Hardware Wizard

Choose Next. Select "Search for the best driver for your device (Recommended)" and

Choose Next.

When a list of search locations is displayed, place a checkmark on "Specify a location"

and use Browse to select the DRIVERS\TOUCHSCREEN\SAW subdirectory on

CDROM or HDD.

Choose Next. Once the GeneralTouch Touchscreen USB Interface driver has been

detected choose Next again.

Wait while driver files are copied to your computer. Insert your Windows CD if

prompted.

Choose Finish.

B). If Windows DOES NOT START the New Hardware Wizard

After Windows loads, click the "Start" button, and then click "Control Panel", "System",

"Device Manager".

In the Device Manager, right click on the USB Human Interface Device, and then click

on Properties, Driver tab, Update Driver, Next. Select "Search for the best driver for your

device (Recommended)" and Choose Next.

When a list of search locations is displayed, place a checkmark on "Specify a location"

and use Browse to select the DRIVERS\TOUCHSCREEN\SAW subdirectory on

CDROM or HDD.

Choose Next. Once the GeneralTouch Touchscreen USB Interface driver has been

detected choose Next again.

Wait while driver files are copied to your computer. Insert your Windows CD if

prompted.

Choose Finish.

2. Double-click the "GeneralTouch Touchscreen" icon in "Control Panel",you can

change your touchscreen settings, (For more information about touchscreen

Settings,please refer to Calibration of the Touchscreen on chapter 4)

NOTE： The Anypos maybe installed the third-part software in the testing process,

but the software is only used for test, and it was deleted before shipping.