User's Manual

54
8-1-2-4 STOPPING THE SEARCH
While the search process is in progress (not stopped), press the [VFO] key (displaying the data
on-screen before search was started).
8-1-2-5 SELECTION OF SEARCH BANK
There are 20 search banks. While searching, rotate the sub dial to step through search banks which
contain data. If no data is programmed in the nominated search bank, the next bank containing valid
data will be used.
8-1-2-6 PROGRAMMING A SEARCH BANK
Each of the 20 search banks may be programmed with different frequency limits, receive modes, etc.
To program a search bank, perform the following steps:
1. Press the [FUNC] key, and then press the [1] key to access the search program menu.
2. Rotate the sub dial to select the search bank to program or overwrite.
3. Press the [DOWN] key to move the cursor downward. Using the numeric keypad, enter the lower
frequency limit in MHz format. (Do not press the [MHz] key this time.) After an entry of the
frequency, the cursor will automatically move downward.
4. Using the numeric keypad, enter the upper frequency limit in MHz format. (Do not press the [MHz]
key this time). After an entry of the frequency, the cursor will automatically move downward.
5. Rotate the sub dial to select the receive mode. If “AUTO” is selected, the IF bandwidth and
frequency step will be entered automatically.
6. If you selected other than auto mode, press the [DOWN] key and enter the IF bandwidth and
frequency step manually.
7. Press the [DOWN] key to enter the search text.