User's Manual

65
4. Rotate the main dial to select Antenna 1.
Note: When an optional AS5000 is not connected, Antenna 3 and 4 are selected as Antenna 1.
5. Rotate the sub dial to select the desired program number 0.
If the programmed channel is empty, “----.------“ is displayed.
To delete the current channel, press the [PASS] key.
6. Press the [1], [0], [0], [MHz] key to enter the upper limit frequency.
7. Press the [2], [5], [MHz] key to enter the lower limit frequency.
8. On the next screen, rotate the main dial to select Antenna 2.
9. Rotate the sub dial to select the desired program number 0.
10. Press the [3], [0], [0], [MHz] key to enter the upper limit frequency.
11. Press the [2], [0], [0], [MHz] key to enter the lower limit frequency.
12. To confirm programming, press the [CLR] key.
To continue programming, repeat above steps from step 3.
9-8 CONFIGURE SD INFO
The AR5001D has a built-in SD memory card interface used for voice recording and/or memory
management.
To display information of the inserted SD memory card, perform the following steps:
1. Insert a SD memory card with a printed label upward facing the slot on the front panel until you can
hear a click.
2. Wait until “SD” appears on the top of the LCD.