User's Manual

6
Main features:
 Wide frequency coverage: 40 kHz to 3.15 GHz, with no interruptions
(Cellular blocked for the US consumer version)
 45.05 MHz IF DSP (Digital Signal Processing)
 HF direct sampling
 No AGC in the analog processing circuit
 Computer simulated high grade RF frontend
 PC controllable
 DDS (Direct Digital Synthesizer) local oscillator
 Accurate reference frequency (0.01 ppm with an optional GPS unit)
 Analog TV reception in both NTSC and PAL formats
 IF analog signal output (45.05 MHz, +/- 7.5 MHz for a total of 15 MHz bandwidth)
 Multi-mode unit capable of receiving AM (Synchronous), ISB, USB, LSB, CW, AIQ (AF-IQ),
WFM including FM stereo (optional headphone or stereo speakers required), NFM and
P25 (APCO25) digital (optional)
 Composite video output on the rear panel of the unit
 SD card interface
 Selectable IF bandwidths: 200 Hz, 500 Hz, 3 kHz, 6 kHz, 15 kHz, 30 kHz, 100 kHz, 200 kHz,
and 300 kHz along with the ability to shift the IF
 CTCSS and DCS selectable squelch functions
 DTMF tone decode
 Built-in voice-inversion descrambling (Not available for the US consumer version)
 CW pitch control, AGC, AFC
 Auto-notch, noise reduction (NR), noise blanker (NB)
 Fast Fourier Transform (FFT) analyzer for fast spectrum display processing
 12 kHz I/Q output for DRM® PC receiver
 USB 2.0 interface
 Two antenna ports (Type N)
 Up to 4 antenna ports (Optional AS5001 antenna switch required)
 5 VFO’s, 2,000 alphanumeric memories
 Simultaneous monitoring of up to three channels
 Digital Voice Recording (with a SD memory card)
 I/Q output with 1 MHz bandwidth (with an optional I/Q unit)
 LAN (Local Area Network) control (with an optional LAN interface)
 P25 (APCO25) decode (conventional mode) (with an optional P25-2300)
 Antenna input level readout (in dBm, dBμ selectable)