User's Manual

76
5
5 MHz ~ 10 MHz
6
10 MHz ~ 15 MHz
7
15 MHz ~ 20 MHz
8
20 MHz ~ 25 MHz
5. Press the [MHz] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry, or press the [DOWN] key to move to the next item
on the configuration menu.
Note: On the spectrum scope screen, signals of only the selected frequency range
can be displayed while the filter is on.
10-12 VIDEO OUT (VIDEO OUTPUT)
Note: This function operates with a frequency of 25 MHz or higher.
The AR5001D has a built-in video decoder and composite video signal output is available from the video
output connector on the rear panel.
Note: Digital broadcast TV cannot be decoded with the AR5001D.
To activate the video output function, perform the following steps:
1. Press the [FUNC] key, and then press the [0] key.
2. Press the [DOWN] key several times to select “VIDEO OUTPUT” in reverse contrast.
3. Rotate the sub dial to select on/off.
4. Press the [MHz] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry, or press the [DOWN] key to move to the next item
on the configuration menu.
10-13 VIDEO IMG (VIDEO MODULATION POLARITY)
Note: This function operates with a frequency of 25 MHz or higher.
In some cases, certain FM video signals may be transmitted with an IF frequency reversed, and
consequently, the received video signal cannot be properly decoded.
The AR5001D has a shift direction reverse function to correct the problem.
To activate the video modulation polarity function, perform the following steps:
1. Press the [FUNC] key, and then press the [0] key.