User Manual

ManualsBrandsAOYUE ManualsSoldering EquipmentHot Air Soldering Station AOYUE 768 (220 V)

A. Replacing the Hot Air Gun heating element

1. Remove the screws which secure the handle and slide the cord tube.

2. Open the handle. Disconnect the ground wire and remove the pipe.

3. Remove the heating element by disconnecting the terminal.

4. Insert a new heating element and reconnect the terminal. Handle the

heating element with care. Never rub its wire. Reconnect the ground

wire after replacing the element.

5. Assemble the handle in the reverse order of disassembly.

B. Care for the Soldering Iron tip.

Always keep the solder-plated section of the tip coated with a small amount

of solder. If the tip is coated with oxide, the tip’s heat conductivity will be

lowered. Coating the tip with a small amount of fresh solder ensures

maximum heat conductivity.

OPERATING PROCEDURE

IV. DC POWER SUPPLY

1. Turn on the power switch. Make sure that the connectors are properly

attached.

2. Press the function button. It will then display the

voltage and current supply.

3. Adjust DC voltage regulator knob for desired output voltage. DC voltage

output ranges from 1-15 V.

WARNING: The display will indicate the following when short circuit occurs.

This warns the operator that the power switch should be immediately

turned off and discontinue operation. Repeat the process again

making sure that all connection are properly connected. The system will

incur permanent damage when short circuit for more than 20 seconds

occur.

MAINTENANCE

VOLTAGE SUPPLY

PACKAGE INCLUSION

SPARE PARTS LIST

Part No. Description

10094 Hot air gun heating element

30106S Plastic handle of hot air gun

S012 Hot air gun complete handle

20962 Hot air gun metal pipe

P004 Diaphragm Pump

B004 Soldering Iron complete handle

C001 Soldering Iron heating element

20170-1 Soldering Iron Tip enclosure

Int 768 Main Station

Hot Air Gun and

Hot Air Gun Holder

Air Nozzles

(1124, 1130, 1197, 1010, 1313, 1919)

Power Cord

939 Vacuum

Suction Pen

G001 IC Popper

2630 Soldering Iron Holder

with Solder Wire Stand

Soldering Iron with Tip

10013 DC Connecting Wires

Soldering Iron

Spare Heating Element