User Manual

4
SPECIFICATIONS
MAIN STATION
Power Input : available in 110V / 220V
Station Dimensions: 188(w) x 126(h) x 250(d) mm
Weight: 5.6Kg
SOLDERING IRON
Power Consumption: 45W
Temperature Range: 200°C - 480°C
Heating Element: Ceramic Heater
Output Voltage: 24V
HOT AIR GUN
Power Consumption: 550W
Temperature Range: 100°C - 480°C
Heating Element Metal Heating Core
Pump/Motor Type: Diaphragm Pump
Air Capacity: 23 l /min (max)
POWER SUPPLY
Total Current: 1.5A
DC Output Voltage: 0-15V
9
II. AUTOMATE HOT AIR REWORKING
This is an optional setting. You can set reworking time from 0-9999
seconds then it automatically turns off.
To activate this function:
1. Set the time by using the button. It is preset at 300 seconds.
2. After preferred automate rework time has been set. Press the
function button to start the countdown.
3. Upon starting the countdown, you can still adjust the hot air gun
temperature but you would not be able to re-adjust the time. Pressing the
button again would pause the countdown of the automate reworking.
4. Hot air gun will start decreasing temperature once automate rework time is
finished.
5. To reset or restart the automation time, Un press function
button, then repeat steps 1-2.
6. To resume manual hot air reworking just press the button.
OPERATING PROCEDURE
III. SOLDERING IRON
1. Check if the Soldering Iron is attached properly to the 6-pin receptacle and
the vacuum tube is securely connected.
2. Be sure that all function buttons are not pressed.
3. Turn on the Power Switch.
4. Press the function switch to turn on soldering iron
function.
5. Solder iron is set to automatically increase temperature to 200°C upon
turning on. It will show the set temperature when you are adjusting the
temperature, then it will automatically switch to display the actual
temperature when you have finished setting the temperature.
6. Set the temperature using the button.
7. Start using when real temperature reaches the set temperature.
AUTOMATE
RESET
AUTOMATE
AUTOMATE
The set temperature will display
the letter “A” indicating that
automation is turned on.
SOLDER IRON
When soldering temperature displays “OFF”, press
the RESET button once to reset the system, if it still
displays “OFF” then it means that the soldering iron
is not connected properly to the unit.