User Manual

8
ReballingwithReflowoven:
1. CarefullyremovetheBGAfromthebottommodule.
2. PlaceBGAinsideareflowovenforreballing.
3. ReflowoventemperatureprofileshouldbeadjustedtofittheBGAto
bereballed.
4. AllowBGAtocooldownbeforehandling.
5. Cleanoffexcessflux.
ReballingwithInfraredsystemsandHotairguns:
1. When using infrared systems or hot air guns, it is critical that the
temperatureappliedtotheBGAbeverysimilartotherecommended
componentreflowprofile.
2. The BGAcan be removed and placed in apreheating system, or di
rectlyreflowedusingtheinfraredgun.
3. AllowBGAtocooldownbeforehandling.
4. Cleanoffexcessflux.
Repeatability:
ForsametypeBGAreballing,Thesesimpleprocedurebelowwillproduce
perfectalignmentwithnoadditionaladjustmentstothemodules.
1. PlacethenextBGAtobereballedontotheholder.
2. Snaponuppermodule.
3. Followapplyingsolderpasteprocedure.
4. Reflow.
Manufacturer:
AOYUETONGYIELECTRONICEQUIPMENTFACTORY
JishuiIndustrialZone,Nantou,ZhongshanCity,
GuangdongProvince,P.R.China
htt p://www.aoyue.com
BGAREBALLINGWITHSOLDERPASTE
INSTRUCTIONMANUAL
ThankyouforpurchasingAoyueBGAreballingsystem.
Pleasereadthismanualbeforeoperatingtheequipment.
Keepmanualinaccessibleplaceforfuturereference.
BGAReBallingSystem