Manual

11
6.5 USING THE LED LIGHT / SIGNAL LAMP
To switch on the LED lamp continuously (Position 5 in the
overview), keep the switch (Position 1 in the overview) of
the Powerpack pressed for approx. 3 seconds. Then, you
can switch the following light functions one after anoth-
er by pressing the switch again: fast ashing – SOS – OFF.
6.4.1 POSSIBLE ERRORS DURING JUMP START
The control lamp of the Smartbox does not shine green
permanently:
• The terminal clamps have no contact or poor
contact to the battery callipers

Clean the battery poles and reattach the terminal
clamps
• The battery of the Powerpack is not adequately
charged

Charge the battery
• The current required for the jump start exceeds the
possibilities of the Powerpack

Use a Powerpack with greater performance
If your USB device has a USB-C port, you can use the
supplied USB-C cable for charging. For other ports, use a
cable suitable for your device. These instructions describe
how to use the supplied USB-C charging cable. Insert
the USB-A plug into the USB output (position 4 in the
overview) of the Powerpack. The USB-C plug, connect
to your USB device. Press the switch (position 1 in the
overview) of the Powerpack to start the charging process.
The display shows the charging voltage (position 14 in
the overview) and the charging current (position 15 in
the overview).
After charging, rst disconnect the charging cable from
the Powerpack, then remove the charging cable from
your USB device.
6.6 CHARGING USB DEVICES
7.2 STORAGE
When it is not in use, the Powerpack should be stored in
a dry place. Do not expose the Powerpack to moisture,
oil, dust, dirt, high temperatures, excessive vibrations or
mechanical stresses. Always disconnect the jump lead
from the Powerpack before storage to ensure that no
short circuits can occur between the terminal clamps.
7. CLEANING, STORAGE AND MAINTENANCE
7.1 CLEANING
Only clean the Powerpack with a soft cloth and do not use
any aggressive cleaning agents or solvents. Never allow
liquids to ingress into the housing.
7.3 MAINTENANCE
When the Powerpack is not in use, recharge it once it
reaches a battery capacity of 25%.
8. NOTES REGARDING ENVIRONMENTAL
PROTECTION
The packaging is made up of environmental-
ly friendly materials which may be disposed
of via your local recycling points. Do not put
electrical devices into the household waste.
Electronic and electrical devices must be
collected separately and sent for environmen-
tally friendly recycling. Contact your commu-
nity or town administration for information
regarding the disposal of electrics.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
[phone]
[phone] – 160
[e-mail]
www.eal-vertrieb.com