Specifications

WWW.APART-AUDIO.COM
10
1)Channel2unbalancedinputoncinchconnectors:usethetoporbottomcinchconnectorto
applyanunbalancedsignalonchannel2.Theseconnectorsarewiredinparallel,thismeans
you can use the second connector as a signal link connector.
2)Channel2balancedinputonNeutrikXLRconnector,thisconnectoriswiredinparallelto
connector‘3’.Thisallowsyoutolinkthebalancedsignaltoanotheramplier.
3)Channel2balancedinputonNeutrikXLRconnector,thisconnectoriswiredinparallelto
connector‘2’.Thisallowsyoutolinkthebalancedsignaltoanotheramplier.
4)Groundliftswitch:usethisswitchtoliftorconnectaudiogroundtosafetyground.Thiscanbe
usefull in case of hum.
5)Speakerloadimpedanceselectorchannel2:setthisselectorcorrectlyaccordingtothe
actualloadimpedance.For4to8ohmsapplications:switchisnotpushedin.For2to3
ohmapplications:pushthebuttonin.Pleasenotethattheimpedancementionedisthetotal
loadoftheamplierchannel,thismeansthatifyouconnectforexample3speakerswith8
ohmimpedance,youMUSTpushthebuttoninbecausetheloadontheamplieris8:3=
2.7 ohms. In case of bridge operation this button has no function. Use channel 1 impedance
selector in case of bridge operation.
6)Channel2speakerbindingpost:thisconnector
acceptsspeakercableaswellas4mm
banana plugs. Remove the protective cover from the middle of the red/black binding post in
caseyouwanttousebananaplugs.Forbridgemodeapplications,youMUSTusethered
bindingpostsonly:channel2redplugisbridgemodenegativespeakerconnector.
7)Mainscableconnector:plugthemainscableconnectorhere,thissocketalsocontainsamains
fuseholder.Replacethisfuseonlywitha3AT250Vtype.
8)Channel1speakerbindingpost:thisconnectoracceptsspeakercableaswellas4mm
banana plugs. Remove the protective cover from the middle of the red/black binding post in
caseyouwanttousebananaplugs.Forbridgemodeapplications,youMUSTusethered
bindingpostsonly:channel1redplugisbridgemodepositivespeakerconnector.
Rearpanellayout:
1 2 3 4 5 6 7 8 9 10 11 12 13