Specifications

WWW.APART-AUDIO.COM

ANY SUGGESTION?

They are well appreciated and eventually rewarded!

Send your ideas or suggestions to

suggestions@apart-audio.com

CONCEPT1 is developed by

Audioprof nv

Lanteernhofstraat 90

BE-2100 Deurne

BELGIUM

• Please check the carton box for any kind of damage on reception of the goods. In case of a damaged

carton, please contact your dealer before opening the carton.

• !!!! Danger !!!! Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals

vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to suf-

ciently intense noise for a sufcient amount of time. Therefore it is recommended that all persons exposed

to equipment capable of producing high sound pressure levels, such as this amplier, be protected by hear-

ing protection while installing or operating this unit.

• Read all documentation before operating your equipment.

• Keep all documentation for future reference.

• Save the carton and packing material even if the equipment has arrived in good condition.

• Should you ever need to ship the unit, use only the original factory packing.

• Do not spill water or other liquids into or on the unit.

• Make sure power outlets conform to the power requirements listed on the back of the unit.

• Do not use the unit if the electrical power cord is frayed or broken.

• Have gain controls on ampliers turned down during power-up to prevent speaker damage if there are high

signal levels at the inputs.

• Do not connect the inputs / outputs of ampliers or consoles to any other voltage source, such as a battery,

mains source, or power supply, regardless of whether the amplier or console is turned on or off.

• Power down & disconnect units from mains voltage before making connections.

• Do not use the unit near stoves, heat registers, radiators, or other heat producing devices.

• Do not operate equipment on a surface or in an environment which may distort the normal ow of air

around the unit. If the unit is used in an extremely dusty or smoky environment, the unit should be periodi-

cally “blown free” of dust.

• Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages.

• Do not drive the inputs with a signal level higher than that required to drive equipment to full output.

• Do not run the output of any amplier back into another input.

•In case of mal-function this device should be serviced by qualied service personnel only.

Safety Instructions