Specifications

[e-mail]
5
CONCEPT1T Version
Difference on Concept 1T
12 13 14 15
12) Lo-cut right channel/zone 2: when this button is pushed, the signal to the internal power amplier
reduces the sub bass frequencies for driving small sized top speakers. It works ideally in combination with
subwoofers
13) Right channel/zone 2 output: use this euroblock connector to connect your right/zone 2 speaker,
minimum load impedance is 4 ohm (167 ohm for T version)
14) Lo-cut left channel/zone 1: when this button is pushed, the signal to the internal power amplier
reduces the sub bass frequencies for driving small sized top speakers. It works ideally in combination with
subwoofers
15) Left channel/zone 1 output: use this euroblock connector to connect your left/zone 1 speaker,
minimum load impedance is 4 ohm (167 ohm for T version)
16) IR jack: connect the optionally available IR remote receiver on this minijack connector: Sleeve =
GND, ring = data, tip = +5VDC. Once this receiver is connected, the IR-receiver behind the front panel is
bypassed.
17) RS232: 9 pin sub D connector for connection of computers or other automated audio
system controllers
18) Ac input: plug in the supplied mains cable here. Check your mains voltage rst !
12) lo-cut Right channel/zone 2: switch not available
13) Right channel/zone 2 output on euroblock connector: minimum load impedance: 167 ohm or
60 watts/100 volt
14) lo-cut Left channel/zone 1: switch not available
15) Left channel/zone 1 output on euroblock connector: minimum load impedance: 167 ohm or 60
watts/100 volt