MIXING AMPLIFIERS MIXING AMPLIFIERS MA200CDR The MA200CDR is developed by Audioprof nv Lanteernhofstraat 90 BE-2100 Deurne BELGIUM info@apart-audio.com www.apart-audio.
MIXING AMPLIFIERS APart MA200CDR mixing amplifier The MA200CDR is a professional 4 zone PA mixing amplifier for commercial and industrial applications. Rarely seen on its competitors, all microphone inputs have integrated speech filters and they are high-class transistor-balanced type, allowing good control of hum and noise over long cables. He's able to drive 8-ohm or constant-voltage loudspeaker lines (50-70-100V).
MIXING AMPLIFIERS MIXING AMPLIFIERS Front panel Technical Specifications 7 Frequency response Distortion Bass control Treble control S/N LED indicators Zone active indicators Muted by priority LED Weight Dimensions Operating temperature 40Hz 25kHz (+1/-3 dB) <0,3% @ -6dB, 1kHz +/- 10dB, 100 Hz +/- 10dB, 10 kHz amplifier: better than 95dB, 22Hz 22kHz line: better than 80dB, 22Hz 22kHz mic: better than 65dB, 22Hz 22kHz limiter active, red signal 100%, yellow signal -25 dB, green power on, green protectio
MIXING AMPLIFIERS MIXING AMPLIFIERS Back panel 15 23 17 21 22 24 25 26 26 27 27 28 SAFETY INFORMATION 29 • Read all documentation before operating your equipment. Retain all documentation for future reference. • Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. • Do not spill water or other liquids into or on the unit. 16 18 19 20 34 35 33 32 28 30 31 28 36 15.
MIXING AMPLIFIERS MIXING AMPLIFIERS How to deal with 100V loudspeaker systems 135 W = 1.5 1.5 W + 1.5 1.5 W + 1.5 1.5 W + 1.5 1.5 W + 3 3W + 3 + 3W 3 3W + 60 60 W + 60 60 W 26. Line 4, 200mV / Mic 4 input. Use only one of these parallel wired inputs at the time! To the XLR3 balanced input you can connect any microphone using a balanced, two wire shielded cable. (1=earth / 2 =hot / 3=cold). For using condenser microphones see 41.
MIXING AMPLIFIERS MIXING AMPLIFIERS MA200CDR Tuner controls Inside Settings Inside settings should only be done by persons familiar to electrical equipment! RADIO MP3 AM / FM mode switch. Each time you press this button, the tuner will switch from FM to AM and the other way round. The actual radio band will be displayed at the left. Scan up / down. By pressing “UP” or “DOWN” a few seconds, the tuner will start to search the next/previous radio station with sufficient signal (auto scanning).
