User manual

WWW.APART-AUDIO.COM
6
Restore Factory Settings:
The factory defaults are shown in the RS232 commands table. In order to restore the factory default
settings, enter the following command: SET RESTORE ON<CR>
This function can also be executed without using RS232 commands. In that case, power off the speaker.
While pushing BASS + and - buttons on the rear panel simultaneously, power up the speaker with the
power switch. The multifunction led will be orange. Release the BASS + and - buttons one second after
powering up. All factory defaults will be restored.
Standby:
The SDQ5Pir can be switched to Standby mode with the IR remote control or with the “SET STANDBY
ON<CR>” instruction. Leaving Standby mode can also be done with IR remote controller or the “SET
STANDBY OFF<CR>” instruction. If an RS232 instruction is sent when the amplier is in Standby mode
or during power on, and the amplier is not ready, it will answer “STANDBY ON”. Please wait until the
speaker is operational (green led at the back is lit) and resend the instruction.