Installation Guide

Continue with the row in this manner. On the final row, there should an
expansion joint of approximately 3/8” between the row and the wall. In doing
this, remember you have to saw off the long edges of the final row of planks, to
fit. Place these planks one by one next to the planks of the last row and tap the
long edges together using the crowbar and hammer. The short edges can be
tapped together using a tapping block.
After installation, you can immediately walk on the floor. This is one of the major
benefits of the cork floating floor.
FINISHING:
Under normal use, no additional finishing is required for your APC cork flooring.
But in the case it is deemed necessary to further protect the seams against water
infiltration or humidity, another coat of varnish or urethane may be applied to the
flooring. The floor would need to be “screened” or lightly abraded for additional
coat to have proper adhesion.
Maitenance and Cleaning:
¾ Clean regularly with a vacuum cleaner or with a mop or damp cloth. If
necessary, use mild detergent.
¾ Never use water directly on the cork floor covering.
¾ Protect floor covering from chairs and other pieces of furniture by using felt on
the feet.