Specification Sheet

WAKOL D 3540 Cork Flooring Adhesive

Product Data Sheet

Description

Solvent free, water based contact adhesive for the interior installation cork tiles on porous

and non-porous subfloors, walls and to permanently adhered, non-cushioned, clean,

existing floor coverings.

Special Features

• Solvent free

• Extra long working time

• Suitable for chair casters

• High initial strength

• Can be walked on

immediately

• For radiant heated floors

Properties

Bases: Synthetic polymers and latex

VOC content: None

Cleaning agent: Water before adhesives cures

Trowels and coverage: Loba microfibre roller #60-80or #120

Coverage: 1 gal. covers 160 sq ft when covering both the tile and the f

Climate conditions at

Work site: 60˚F to 75˚F, 40% to 65% relative humidity

Open time: 30 to 45 minutes, depending on climate conditions and

absorbency of substrates, allow adhesives to dry until it is

clear

Working time: 2 to 3 hours when installing precoated tiles working time is

reduced to 1 to 1.5 hours

Curing time: Curing takes 24 hours, light traffic allowed immediately

after installation

Shelf life: 1 year in unopened container at 70˚F

PAGE 1
WAKOL D 3540 Cork Flooring Adhesive Product Data Sheet Description Solvent free, water based contact adhesive for the interior installation cork tiles on porous and non-porous subfloors, walls and to permanently adhered, non-cushioned, clean, existing floor coverings.
PAGE 2
Subfloors All surfaces shall be dry, smooth and level. They must be structurally sound, solid, well fastened clean and free from dust, oil and grease, paint, wax, old adhesives. Check for curing and parting compounds, surface hardeners and sealers which are known to interfere with the adhesive bond to concrete, as well as loosely bonded toppings, primers or any other deleterious substances that may prevent or reduce adhesion.
PAGE 3
Walls: An even surface is necessary plaster must be leveled with fine, high quality wall filler. To bond dust use WAKOL D 3073 Universal Primer diluted 1:2 with water. Minimum drying time of 24 hours is needed. Application Stir adhesive well before use. Spread adhesive evenly and uniformly on the back of the tile and the subfloor using the recommended roller.