Installation manual

29Uniflair LE Accessories Manual
Condensate Pumps
Overview
Uniflair condensate removal pumps collect and automatically remove water up to 100°C (212°F). The pump
collects water in its integral reservoir. After enough water has been collected, an internal float switch activates
the pump and the water is pumped out. Once enough water has been evacuated from the reservoir, the pump
automatically deactivates.
Important Safety Information
Read the instructions carefully to become familiar with the equipment before trying to install, operate, service,
or maintain it. The following special messages may appear throughout this manual or on the equipment to warn
of potential hazards or to call attention to information that clarifies or simplifies a procedure.
IMPORTANT: For correct wiring installation, refer to the enclosed wiring diagrams. Make certain that line
voltage corresponds to voltage specified on pump motor’s nameplate.
IMPORTANT: All wiring must conform to local electrical codes. In areas without local code, the National
Electrical Code applies.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• To reduce the risk of electrical shock, this pump must be grounded with a properly wired
grounding connection.
• Disconnect electrical power at the power source (fuse box, circuit breaker, etc.) before servicing
pump.
• Do not handle the pump with wet hands, while standing on a wet/damp surface, or in water.
Failure to follow these instructions will result in death or serious injury.
NOTICE
FLAMMABLE FLUIDS
The pump should only be used for liquids compatible with pump component materials. Do not
use to pump flammable or explosive fluids. Do not use in explosive atmospheres.
In any installation where property damage and/or injury could occur as a result of an inoperable
or leaking pump, a backup system such as high level safety float switch and/or alarm is highly
recommended.
Failure to follow these instructions can result in equipment damage.