Installation manual

Pumped Refrigerant System Operation and Maintenance32
Network Configuration
The RDU is shipped with a Network Management Card that enables you to manage the RDU and
attached CMs over your network. Configure the network settings for the Rack PDU Network
Management Card from the display interface. The management card allows remote control and
configuration of the equipment.
Configure the network
Path: Main > Configure Network
MAC Address. Displays the unique network identifier assigned to the Network Management Card of
the RDU at the factory.
IP Address. You will be prompted to enter an Admin password. Enter the password and press ENTER to
return to the IP screen. Press
ENTER again to change the following settings for Manual boot mode only.
• IP: Enter the IP address assigned to the Network Management Card of the cooling unit.
• SM: Enter the subnet mask for the Network Management Card of the cooling unit.
• GW: Enter the default gateway for the Network Management Card of the cooling unit.
Boot Mode. Set the method by which the Network Management Card of the RDU will acquire its
network settings.
• Manual: Enter the IP Address, subnet mask, and default gateway using the IP Address menu.
• BOOTP: Set the Network Management Card of the unit to obtain its network settings from a
BOOTP server.
• DHCP: Set the Network Management Card of the unit to obtain its network settings from a
DHCP server.
By default, DHCP requires an APC cookie before it will accept an IP address. See
“DHCP” on page 1 for more information.
• BOOTPDHCP: Set the Network Management Card of the unit to search for its network settings
from either a BOOTP or a DHCP server.