User manual

InRow RC Installation20
Joining the Equipment to Enclosures
Joining to NetShelter
™
SX enclosures
The equipment comes with four joining brackets (two for the front and two for the rear).
1. Remove the front and rear
doors. See “Removing the
front and rear doors”.
2. Locate the four joining
brackets. Rotate each bracket
ninety degrees toward the
adjoining enclosure so the
bracket is parallel to the floor
and install using the screws
provided with the enclosure.
For more information, see
the Unpacking, Installation, and Customization manual for the NetShelter SX Enclosure.
Joining to NetShelter VX and VS enclosures
For information on joining the equipment to NetShelter VX and VS enclosures, see the
installation sheet NetShelter
™
SX to VX or VS External Joining Kit—AR7601, AR7602.
ns0618a