User manual

21InRow RC Installation
Leveling the Equipment
Note: The leveling feet at the corners of the equipment provide a stable base if the floor is
uneven, but they cannot compensate for a badly sloped surface.
1. Remove the front and rear doors. See “Removing the front and rear doors” on page 17.
Note: Before removing the front door, unplug the ground wires and any other wire
connections that may interfere with the removal of the doors.
2. For each leveling foot, insert a Phillips PH2 or
slotted screwdriver into the screw above the
leveling foot. Turn the screw clockwise to extend
the leveling foot until it makes firm contact with
the floor.
3. Reinstall the front and rear doors.
Note: Use a 13-mm open-ended wrench to level the equipment without removing the
doors.
CAUTION
SHOCK HAZARD
After reinstalling the front door, reconnect the ground wire and other wire connections.
Failure to follow these instructions can result in equipment damage.
na1572a