Specifications

InRow RP CW Installation28
Leak sensor
Install up to four optional leak sensors (AP9326) as needed.
1. Connect the leak sensor to the equipment
using the plug located on the service bracket,
as shown.
2. Position the leak sensor inside or outside the
equipment.
3. Route the leak sensor to the outside through
either the bottom plate or the door.
4. Secure the leak sensor wire to surfaces using
cable ties and cable tie holders (provided with
the leak detector).
na1584a
LEAK
DETE CT OR
CA BLE
SUCTIO N
DIS CHA RGE
SERVICE
na2266a
na2073a
Note: Install leak sensors on a
clean surface, and do not allow
them to touch metal that is in an
air stream.