Brochure

13Rack ATS AP44xx Installation and Quick Start
Configure TCP/IP settings in the CLI
1. Log on to the CLI. See “Local access to the command line interface (CLI)” on page 12 or
“Remote access to the CLI” on page 12.
2. Contact your network administrator to obtain the IP address (if needed), subnet mask, and
default gateway for the Rack ATS.
3. Use these three commands to configure network settings. (Text in italics indicates a variable.)
tcpip -i yourIPaddress
tcpip -s yourSubnetMask
tcpip -g yourDefaultGateway
For each variable, type a numeric value that has the format xxx.xxx.xxx.xxx.
For example, to set a system IP address of 156.205.14.141, type the following command and
press
ENTER:
tcpip -i 156.205.14.141
4. Type exit, and then press
ENTER. The Rack ATS restarts to apply the changes.