User Manual

99Rack ATS AP44xx User Manual
Configure FTP server
Path: Configuration > Network > FTP Server
Access: Enable (the default) or disable access to the FTP server.
Port: specify the TCP/IP port (21 by default) that the FTP server uses to communicate with the ATS. The
FTP server uses both the specified port and the port one number lower than the specified port.
You can change the Port setting to the number of any unused port from 5001 to 32768 for added
security. Users must then use a colon (:) to specify the non-default port number. For example, for port
5001 and IP address 152.214.12.114, the command would be ftp 152.214.12.114:5001.
NOTE: FTP transfers files without encryption. For higher security, disable the FTP server, and transfer
files with SCP. Selecting and configuring Secure SHell (SSH) enables SCP automatically.
NOTE: You can use FTP or SCP to configure and update the ATS with StruxureWare Data Center Expert
or EcoStruxure IT as long as the same protocol is enabled on both the ATS and StruxureWare or
EcoStruxure. See your StruxureWare Data Center Expert or EcoStruxure IT documentation for details.
For detailed information on enhancing and managing the security of your system, see the Security
Handbook, available at www.apc.com.