User Manual

Rack ATS AP44xx User Manual106
Configure notifications by group
Path: Configuration > Notification > Event Actions > By Group
To configure a group of events simultaneously:
1. Select how to group events for configuration:
–Select Events by Severity, and then select one or more severity levels. You cannot change
the severity of an event.
–Select Events by Category, and then select events in one or more pre-defined categories.
2. Click Next to select an event action:
– To select any action except Logging (the default), you must first have at least one relevant
recipient or receiver configured.
3. Click Next to do one of the following:
– If you selected Logging on the previous screen and have not configured a Syslog server,
select the Configure Event Log check box.
– If you selected Logging on the previous screen and have configured a Syslog server, select
Event Log or Syslog. See “Configure Logs” on page 114.
– If you selected Email Recipients on the previous screen, select the e-mail recipients to
configure.
– If you selected Trap Receivers on the previous screen, select the trap receiver to configure.
4. Click Next to configure notification parameters. These configuration fields define e-mail
parameters for sending notifications of events:
– If you are configuring Logging settings, select Enable Notification or Disable Notification.
– If you are configuring Email Recipients or Trap Receivers, select Enable Notification or
Disable Notification and set the notification parameters.
5. Click Next to view pending actions and do one of the following:
– Click Apply to accept the changes.
– Click Cancel to revert to the previous settings.
Notification parameters
These configuration fields define e-mail parameters for sending notifications of events. They are usually
accessed by selecting the receiver or recipient name.
NOTE: For events that have an associated clearing event, you can also set these parameters.
Field Description
Delay n time before
sending
If the event persists for the specified time, the notification is sent. If the condition
clears before the time expires, no notification is sent.
Repeat at an interval of n The notification is sent repeatedly at the specified interval (the default is every 2
minutes until the condition clears).
Up to n times During an active event, the notification repeats for this number of times.
or
Until condition clears The notification is sent repeatedly until the condition clears or is resolved.