User Manual

Rack ATS AP44xx User Manual124
Transfer the file to a single ATS
To transfer the .ini file to another ATS, do either of the following:
• From the Web UI of the receiving ATS, select Configuration > General > User Config File.
Enter the full path of the file, or use Browse on your local PC.
• Use any file transfer protocol supported by ATS units, i.e., FTP, FTP Client, SCP, or TFTP. The
following example uses FTP:
a. From the folder containing the copy of the customized .ini file, use FTP to log in to the ATS
to which you are exporting the .ini file:
ftp> open ip_address
b. Export the copy of the customized .ini file to the root directory of the receiving ATS:
ftp> put filename.ini
Transfer the file to multiple ATS units
To transfer the .ini file to multiple ATS units, do one of the following:
• Use FTP or SCP, but write a script that incorporates and repeats the steps used for exporting the
file to a single ATS.
• Use a batch processing file and the .ini file utility.
To create the batch file and use the utility, see FAQ article FA156117: go to www.apc.com,
navigate to Support > Resources & Tools > FAQs, then enter the article number in the search
bar.