User Manual

27Rack ATS AP44xx User Manual
boot
Access: Super User, Administrator
Description: Allows the user to get/set the network startup configuration of the device, such as setting
boot mode.
Parameters:
Example: Using a DHCP server to obtain network settings:
apc> boot
E000: Success
Boot Mode: manual
Non-Manual Mode Shared Settings
-------------------------------
Vendor class: <device class>
Client id: XX XX XX XX XX XX
User class: <user class>
After IP assignment: gotoDhcpOrBootp
DHCP Settings
-------------
Retry then stop: 4
DHCP cookie is: enable
BOOTP Settings
--------------
Retry then fail: never
On retry failure: prevSettings
Error Message: E000, E102
Option Argument Description
-b <dhcp | bootp | manual> Define how the TCP/IP settings will be configured when the
Rack ATS turns on, resets, or restarts. See “Configure TCP/IP
and communication settings for IPv4 and IPv6” on page 96 for
information about each boot mode setting.
-c <enable | disable> dhcp boot mode only: Enable or disable the requirement that
the DHCP server provide the APC cookie.
-v <vendor class> dhcp boot mode only: the Vendor Class is APC.
-i <client id> dhcp boot mode only: the MAC address of the NMC, Which
uniquely identifies it on the network.
-u <user class> dhcp boot mode only: the name of the application firmware
module.