User Manual

57Rack ATS AP44xx User Manual

Error Message: E000, E102

xferINI

Access: Super User, Administrator

Description: Use XMODEM to upload an .ini file to the NMC while you are accessing the CLI through a

serial connection. After the upload completes:

• If there are any system or network changes, the CLI restarts and you must log on again.

• If you selected a baud rate for the file transfer that is not the same as the default baud rate for the

Rack ATS, you must reset the baud rate to the default to reestablish communication with the Rack

ATS.

Parameters: None

Example:

apc> xferINI

Enter 'YES' to continue or <ENTER> to cancel : <user enters ‘YES’>

------- File Transfer Baud Rate------------------------------

1- 2400

2- 9600

3- 19200

4- 38400

> <user enters baudrate selection>

Transferring at current baud rate (9600), press <ENTER>...

Start XMODEM-CRC Transfer Now!

150 bytes have successfully been transmitted.

apc>

Error Message: E000, E100

xferStatus

Access: Super User, Administrator

Description: View the result of the last file transfer. See “Verifying Upgrades and Updates” on page 131

for descriptions of the transfer result codes.

Parameters: None

Example:

apc> xferStatus

E000: Success

Result of last file transfer: OK

Error Message: E000