Technical information

Chapter 3:
How to Configure a UPS
PowerNet MIB Reference Guide
22
upsAdvConfigSensitivity Define the sensitivity of the UPS to input line abnormalities
or “noise.”
• auto (1): The only setting recognized by UPSs with
automatic voltage regulators, e.g Matrix-UPS and
Symmetra UPS.
• low (2)
• medium (3)
• high (4)
upsAdvConfigLowBatteryRunTime
2
Define when a low-battery condition will occur, based on
how much battery runtime remains, in seconds.
upsAdvConfigReturnDelay
2
Define the time in seconds that a UPS in sleep mode will
wait after input power returns before turning on its power
outlets. (In sleep mode, a UPS waits, with its power outlets
turned off, for input power to return.)
upsAdvConfigShutoffDelay
2
Define the delay time, in seconds, used for graceful turn-
off, reboot, and sleep-control options. (See How to Control
a UPS.) Only Management Cards can use this OID.
upsAdvConfigUpsSleepTime Define how long the UPS will remain in timed sleep,
specified as a multiple of 360 seconds (6 minutes). If a SET
provides a value that is not a multiple of 360, the UPS
rounds the value to the nearest multiple of 360, except that
any value from 1 through 540 is rounded to 360. Only
Management Cards can use this OID.
upsAdvConfigSetEEPROMDefaults Reset the UPS configuration values to the values set at the
factory. Only Management Cards can use this OID.
• noSetEEPROMDefaults (1): The value always returned
by a GET. Setting this value has no effect.
• setEEPROMDefaults (2): Resets the values.
upsAdvConfigPassword Define the 4-byte password used for front-panel access to a
Matrix-UPS or Symmetra UPS. Only Management Cards
can use this OID.
OID Task (page 2 of 3)
1
If a SET specifies an unsupported value, the UPS interprets the value as the next lower allowed
value, as defined by the apcUpsConfigFieldValueRange OID in the tabled set of OIDs
{upsAdvConfigAllowedSetTable}. If the value is less than the lowest allowable value, the lowest
allowed value is used.
2
If a SET specifies an unsupported value, the UPS interprets the value as the next higher allowed
value, as defined by the apcUpsConfigFieldValueRange OID in the tabled set of OIDs
{upsAdvConfigAllowedSetTable}. If the value is higher than the highest allowable value, the
highest allowed value is used.