Technical information

Chapter 3:
How to Use OIDs for 3-Phase UPS Models
PowerNet MIB Reference Guide
27
[upsPhaseOutput]
All of the OIDs in this category are read-only except for the upsPhaseOutputName OID, a
{upsPhaseOutputEntry} in the {upsPhaseOutputTable}.
OID Task
upsPhaseNumOutputs
{upsPhaseOutputTable}
{upsPhaseOutputEntry}
upsPhaseOutputTableIndex
upsPhaseNumOutputPhases
upsPhaseOutputVoltageOrientation
upsPhaseOutputFrequency
upsPhaseOutputName
Use these read-only OIDs to obtain information about
the number of output feeds to the UPS, and information
about each of those feeds.
(upsPhaseInputPhaseTable)
{upsPhaseInputPhaseEntry}
upsPhaseInputPhaseTableIndex
upsPhaseInputPhaseIndex
upsPhaseInputVoltage
upsPhaseInputMaxVoltage
upsPhaseInputMinVoltage
upsPhaseInputCurrent
upsPhaseInputMaxCurrent
upsPhaseInputMinCurrent
upsPhaseInputPower
upsPhaseInputMaxPower
upsPhaseInputMinPower
Use the read-only OIDs to obtain the following
information for each input phase:
• The output voltage, output current, output load and
output power now.
• The minimum and maximum value recorded for the
output voltage, output current, output load and output
power since the corresponding counters were reset by
the OIDs in the [upsPhaseResetValues] group.
The number of entries in the table depends on the sum of
the values reported for upsPhaseNumOutputPhases in
the {upsPhaseOutputTable} above.