Technical information

Chapter 5:
[sPDUMasterConfig] Master Configuration OIDs
PowerNet MIB Reference Guide
40
[sPDUMasterConfig] Master Configuration OIDs
The [sPDUMasterConfig] category has three OIDs that allow you to use SETs to define two overall operational values
and a name for the MasterSwitch unit. If the MasterSwitch unit uses firmware version 2.x, the
sPDUMasterConfigReboot OID is read-only.
OID Task
sPDUMasterConfigPowerOn
Define how long a delay will occur after power is applied to the MasterSwitch unit
until it supplies power to the outlets.
• -1: Never apply power automatically; you must turn on outlets manually.
• 0: Apply power immediately, with no delay.
• 15: 15-second delay.
• 30: 30-second delay.
• 45: 45-second delay.
• 60: 1-minute delay.
• 120: 2-minute delay.
• 300: 5-minute delay.
Note:
Each outlet's sPDUOutletConfigPowerOn Time configuration OID also
affects the time it takes for an outlet to provide power. See [sPDUOutletConfig]
Outlet Configuration OIDs.
sPDUMasterConfigReboot
Define how long a delay after master power is turned off during a reboot sequence
until master power is turned on again. This OID checks the delay that is set for each
outlet and reports the longest of these delays. This OID is read-only for firmware
version 2.x.
• 5: 5-second delay.
• 10: 10-second delay.
• 15: 15-second delay.
• 20: 20-second delay.
• 30: 30-second delay.
• 45: 45-second delay.
• 60: 1-minute delay.
Note:
Each outlet's sPDUOutletConfigPowerOnTime configuration OID also affects
the time it takes for an outlet to provide power. See [sPDUOutletConfig] Outlet
Configuration OIDs.
sPDUMasterConfigPDUName
Define a name (of up to 20 characters) for the MasterSwitch unit.