Technical information

Chapter 8:
[atsCalibration] Calibration OIDs
PowerNet MIB Reference Guide
66
[atsCalibration] Calibration OIDs
The [atsCalibration] category has five read-only OIDs and three tabled sets of read-only OIDS that return values related
to the Automatic Transfer Switch’s input lines and output lines, including information on their phases and calibration
factors. The OIDs also identify the number, type, and calibration factors of power supplies supported.
OID Information Reported
atsCalibrationNumInputs The number of input lines to this device.
atsCalibrationNumInputPhases The number of phases per input line for this device.
{atsCalibrationInputTable}
{atsCalibrationInputPhaseEntry}
atsCalibrationInputTableIndex
atsCalibrationInputPhaseTableIndex
atsLineVoltageCalibrationFactor
A tabled set of OIDs providing the following information for
each phase of an input line:
• The input identifier.
• The input phase identifier.
• The Line Voltage Calibration factor (set at the factory).
atsCalibrationPowerSupplyVoltages The number of power supply voltages that this device
supports, which defines the number of rows in
atsCalibrationPowerSupplyVoltageTable (one entry per
supported voltage: 24V, 12V and 5V).
{atsCalibrationPowerSupplyVoltageTable}
{atsCalibrationPowerSupplyVoltageEntry}
atsCalibrationPowerSupplyVoltageTableIndex
atsCalibrationPowerSupplyVoltage
atsPowerSupplyVoltageCalibrationFactor
A tabled set of OIDs providing the following information for
each power supply voltage supported by this device:
• The power supply voltage identifier: 24 V (1), 12 V (2), or 5
V (3).
• A description of the power supply voltage:
powerSupply24V (1), powerSupply12V (2), or
powerSupply (3).
• The Line Voltage Calibration factor (set at the factory).
atsCalibrationNumOutputs The number of output lines from this device. This number
defines the number of rows in atsCalibrationOutputTable.
atsCalibrationNumOutputPhases The number of output phases used in this device.
{atsCalibrationOutputTable}
{atsCalibrationOutputEntry}
atsCalibrationOutputTableIndex
atsCalibrationOutputPhasesTableIndex
atsOutputCurrentCalibrationFactor
A tabled set of OIDs providing the following information for
each output line:
• The output identifier.
• Description of each calibration factor for each output phase
used in this device and one for neutral: phase 1 (1),
phase 2 (2), phase 3 (3), and neutral (4).
• The output current calibration factor measured in Amps.