Datasheet

24 MasterSwitch VM: Installation and Quick Start Manual
Quick Configuration for Controller-based Systems
Over the Network by ARP. (Address Resolution Protocol) To
configure MasterSwitch VM TCP/IP settings using
ARP:
1. Connect the unit to the network.
2. From a command prompt on a computer connected to the
local subnet, use this format:
arp -s ip_addr_card mac_card. See the example below:
arp -s 159.215.240.22 00-c0-b7-78-ad-90
3. Type telnet ip_addr. See the example below:
telnet 159.215.240.22
The default user name and password are both apc. Configure
the correct Subnet Mask and default Gateway in the TCP/IP
section of the Network menu.
Note
Look for the MAC address on the Quality
Assurance slip or on the
TCP/IP menu from
the Control Console.