Datasheet

®
®®
®
USER’S GUIDE masterswitch vm
Initial setup (with controller)
You must define three TCP/IP settings for the MasterSwitch VM before it
can operate on the network.
• IP address of the Management Card
• Subnet mask
• IP address of the default gateway
For instructions on configuring the MasterSwitch VM network settings, see
the installation manual included with the unit and on the
CD. After you
configure MasterSwitch VM, no further configuration is required. The
remaining MasterSwitch VM properties are pre-configured at the factory.
However, you may want to customize these properties for your application.
See Menu Items for more details on changing MasterSwitch VM properties.
Configuring outlets for operation
MasterSwitch VM allows you to configure an outlet for on-demand
operation, which consists of On, Off, and Reboot Outlet Control Actions.
The sections that follow describe each operation that you can configure for
your MasterSwitch VM unit.
Immediate On. This action immediately turns an outlet on.
Immediate Off. This action immediately turns an outlet off.
N
ote
If a default gateway is not present, enter an IP address of a
computer on the same subnet that is always active.