User`s guide

–26–
HowtoManageMasterSwitchplus
Remote Management Interfaces
continued
Control Console
interface,
continued
2. Check the terminal port for the following communication
settings:
Note: To change the communications settings using HyperTerminal,
follow the steps below in the order given:
a. Make the needed changes.
b. Select
Disconnect
in the Call menu.
c. Select
Connect
in the Call menu.
3. Press
ENTER
and log into the Control Console.
The procedure for logging into the Control Console is the same
for both Telnet and a serial interface. When prompted, type your
user name and press
ENTER
and then type your password and
press
ENTER
.
See page 65 for a map of the Control Console.
SNMP
MasterSwitch
plus
fully supports SNMP—all unit and outlet properties
are configurable through SNMP. For complete instructions on how to
use SNMP to manage MasterSwitch
plus
,opentheMibguide.pdf file in
the Snmp folder on the CD.
Baud Rate 2400
Data Bits 8
Stop Bits 1
Parity None
Handshaking None
Local Echo Off
Terminal Type
ANSI
(VT100)