Datasheet

ManualsBrandsAPC ManualsSmoke DetectorsAP9323

Smoke Sensor—AP9323

Use the mounting bracket to install the sensor in an APC NetShelter

or other standard 19-inch

enclosure. To install in a NetShelter enclosure:

1. Remove the base of the sensor.

2. Attach the base to the bracket, using the 4×8mm screws (provided).

Warn

Do not connect the smoke sensor to anything other than the Environmental

Management System. Doing so could damage the sensor.

Note

The sensor will operate best if placed near the top of the enclosure.

Summary of content (4 pages)

PAGE 1
Smoke Sensor—AP9323 Do not connect the smoke sensor to anything other than the Environmental Management System. Doing so could damage the sensor. Warning The sensor will operate best if placed near the top of the enclosure. Note Use the mounting bracket to install the sensor in an APC NetShelter® or other standard 19-inch enclosure. To install in a NetShelter enclosure: 1. Remove the base of the sensor. 2. Attach the base to the bracket, using the 4×8mm screws (provided).
PAGE 2
Smoke Sensor—AP9323 3. Route the cable through the hole on the mounting bracket. 4. Secure the sensor to the base— rotate it clockwise and lock it in place. 5. Choose a location in the enclosure for the sensor. It may be mounted at any unused position along one of the front or rear vertical mounting rails. 6. Install two caged nuts (provided with the enclosure) above and below a notched hole on one vertical mounting rail in your chosen location. The sensor occupies two U-spaces.
PAGE 3
Smoke Sensor—AP9323 7. Turn the mounted sensor over so that the cable points toward the roof of the enclosure. Align the mounting holes of the bracket with the installed caged nuts. Insert and tighten the screws (provided with the enclosure). 8. Neatly route and secure the 12-foot cord with tie-wraps or cable clips. 9. Plug the smoke sensor into the port marked Smoke on the rear panel of the Environmental Management System.
PAGE 4
APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways: • Visit the APC Web site to find answers to frequently asked questions (FAQs), to access documents in the APC Knowledge Base, and to submit customer support requests. – www.apc.com (Corporate Headquarters) Connect to localized APC Web sites for specific countries, each of which provides customer support information. – www.apc.