User Manual

Temperature/Humidity Sensor

(AP9335TH) Installation Instructions

Inventory

Installation

Note: If you use a tie wrap to secure the sensor, tighten the tie wrap over the recessed

channel on the sensor. If you use the housing clip, make sure the protrusions on the inside

of the clip snap into the slots in the recessed channel.

Note: Use adhesive cable tie holders, tie wraps, and wire clips to secure the sensor cable.

4-m (13.12-ft) temperature/humidity

sensor (1)

25.4-mm x 25.4-mm

(1-in x 1-in) temperature/

humidity sensor mount (1)

Housing clip (1)

203-mm (8-in) tie wrap (5)

#8 x 3/4-in sheet

metal screw (1)

#8 wall anchor (1)

19-mm x 19-mm (3/4-in x 3/4-in) adhesive

cable tie holder (2)

Wire clip (6)

PAGE 1
Temperature/Humidity Sensor (AP9335TH) Installation Instructions Inventory 4-m (13.12-ft) temperature/humidity sensor (1) 25.4-mm x 25.4-mm (1-in x 1-in) temperature/ humidity sensor mount (1) Housing clip (1) 203-mm (8-in) tie wrap (5) #8 x 3/4-in sheet metal screw (1) #8 wall anchor (1) 19-mm x 19-mm (3/4-in x 3/4-in) adhesive cable tie holder (2) Wire clip (6) Installation Note: If you use a tie wrap to secure the sensor, tighten the tie wrap over the recessed channel on the sensor.
PAGE 2
Vertical rail Door Wall Note: Drill a 4.76-mm (3/16-in) pilot hole for the wall anchor. Customer support and warranty information is available at the APC Web site, www.apc.com. © 2008 American Power Conversion. All rights reserved. All APC trademarks are property of American Power Conversion. Other trademarks are property of their respective owners.