User Manual

Basic tab
Element Description
SIM PIN
For modems that use a SIM (subscriber
identification module), identify the PIN (personal
identification number) used to unlock that SIM.
Note: For modems that do not have a SIM, this
field must be blank.
Confirm SIM PIN
Identify the SIM PIN, again.
Service Center (SMSC)
Identify the address of the Short Message
Service Center (SMSC) used by your SMS
service.
The SMSC is essentially an SMS server that
is used to send the messages. The address
for the SMSC is typically programmed into
the SIM and, therefore, you can typically
leave this field blank.
Note: Entering a value in this field will override
automatic SMSC selection.
Destination
Identify the address used to send an SMS to an
e-mail destination.
When an SMS message needs to be sent to
an e-mail destination address, the NetBotz
Appliance puts the e-mail address at the
beginning of the message and sends it to
the Destination address. The SMSC
receives the message, pulls out the e-mail
address, and sends the remainder of the
message to that address.
Note: The default value for this field is
0000000000, the value that works with AT&T
Wireless.
Interrupt PPP When an SMS Alert Occurs
Select this option if your modem supports both
SMS and Point-to-Point Protocol (PPP)
communications, to allow SMS communication
to override PPP communication when
necessary.
If PPP dial-out is active when the NetBotz
Appliance needs to send an SMS alert, PPP
will be interrupted while the SMS message
is sent.
Once the SMS message has been sent, the
PPP connection will be reestablished.
Advanced tab
Element Description
Send Debug Messages to Syslog
Select to have debug messages forwarded to the
syslog host.
StruxureWare Central 6.3.0
244