Datasheet

NetShelter VS Enclosure 9
Installation
How to Install the NetShelter VS Enclosure
The first step when installing the enclosure is to level it. You can also provide additional stability
using any of the methods described in this section.
How to level the enclosure
Leveling feet are attached under the enclosure at each corner. The leveling feet help provide a stable
base if the selected floor space is uneven, but they cannot compensate for a badly sloped surface. You
can remove the casters and leveling feet to allow the base of the enclosure to rest directly on the floor.
1. Move the enclosure to a relatively level location.
2. For each leveling foot, fit the 14-millimeter end of
the open-ended wrench (provided) to the hex head
just above the round pad on the bottom of the foot.
Turn the wrench clockwise to extend the leveling
foot until it makes firm contact with the floor.
3. Use a level to determine which feet need further
adjustment to level the enclosure. Adjust them as
necessary.
How to remove the casters and leveling feet (optional)
1. Lay the enclosure on its side.
2. Remove the four hex nuts from each of the casters and remove the casters.
3. For each leveling foot, fit the 14-millimeter end of the open-ended wrench (provided) to the hex
head just above the round pad on the bottom of the foot. Turn the wrench clockwise to extend
and remove the leveling foot.
Warn
i
ng
To avoid personal injury or damage to the enclosure, two people should
support the enclosure.