Datasheet

6/11
5 If you plan to install the bezel:
install M6 caged nuts into the
square mounting holes next to each
of the upper pencil marks that you
made in Step 4. For detailed
instructions on installing caged
nuts, see the NetShelter User Man-
ual, “Caged Nuts.”
Attach the slides to the mounting rails:
6 Attach one of the slides removed
in Step 1 to a mounting rail, using
two of the M6 nuts supplied with
the HP NetServer Rack Mount Kit.
Make sure that the slides are prop-
erly oriented with respect to the
mounting rail and that they can be
extended frontward without inter-
ference from the bracket. Repeat
for the second bracket.
Mount the mounting rail/slide assembly to the NetShelter:
7 Place one of the mounting rail/
slide assemblies into the
NetShelter and align the bottom
edge of the front mounting ear
with the pencil mark that indicates
the bottom edge of the bezel. (See
Step 4.)
8 Mount the assembly with three M6
× 12mm flat head screws. Use two
screws in the front of the mounting
rail (J1451A/B and J1491A: bot-
tom two holes; J1452A/B: bottom
and third-from-bottom holes).
Make sure that the mounting rail is
level. Use one screw in the lower
hole at the rear. Repeat Steps 7 and
8 for the second mounting rail/
slide assembly.
Table 4: Installation Procedure for J1451A/B, J1452A/B, J1491A
Step Action Figure
J1452A/B
J1451A/B
J1491A
M6 x 12mm
mounting
screws
Pencil mark at
bottom edge
of bezel
M6 x 12mm
mounting
screws
Pencil mark at
bottom edge
of bezel