Datasheet

8/11
Section 3 — Mounting Instructions for J1455A
To install J1455A into an APC NetShelter, follow the steps in Table 5 below.
Table 5: Installation Procedure for J1455A
Step Action Figure
1 Attach each slide to a mounting
rail, using four (4) 10-32 lock nuts
supplied with the HP NetServer
Rack Mount Kit.
2 Determine the mounting location
of the slide/rail assembly by using
the HP-supplied ears in the same
manner as Table 4, Step 4.
Mount the assembly to the Net-
Shelterwithfour(4)M6× 12mm
slotted screws. Use two screws at
the rear of each mounting rail. Use
two screws in the front of the
mounting rail—one in the bottom
mounting hole and one in the third-
from-bottom mounting hole.