User's Manual

Back-UPS Pro BN 1100/1350/1375/1400/1500 M2 / M2-CA
2
Connect the Battery
The UPS is shipped with the battery disconnected.
Install PowerChute
™
Personal Edition Software
Use PowerChute Personal Edition software to configure the UPS settings. During a
power outage, PowerChute will save any open files on your computer and shut it down.
When power is restored, it will restart the computer.
Note: PowerChute is only compatible with a Windows operating system. If you are
using Mac OSX, use the native shutdown feature to protect your system. See the
documentation provided with your computer.
Installation
Use the USB communication cable supplied with the Back-UPS to connect the data port
on the Back-UPS to the USB port on your computer. On the computer, go to
www.apc.com Search for “PowerChute Personal Edition” then click on “View Details”
to download the latest version of PCPE software. Click the download link and select
Software product. Select the appropriate operating system. Follow directions to
download the software.
 Lay the UPS with the battery door facing
up. The arrows point to the locking tabs of the
battery compartment.
 Press the tabs downwards and pull the
battery door away from the unit to access
the battery modules.
 Using the handles on both sides of the
battery, lift the battery 30 degrees upward to
expose the battery connector. Connect the red
wire as shown above.
 Push the battery into the unit.
 Replace the battery door.
b
u471a
b
u
4
7
2
a
bu473a
bu474a
b
u
4
7
5
a