Network Router User Manual

4
CTEP6 Model
Ground Mount Installation
1. Install an APC approved concrete pad. Contact your dealer or see How to Contact APC, in this
manual for more information.
2. Secure the enclosure to the pad.
0 Battery Enclosure:
Attach the ground skirt to the concrete pad.
Attach the enclosure to the ground skirt.
3 Battery, 6 Battery Enclosures:
Place the enclosure on the pad. The holes on the
enclosure must be aligned with the anchor hooks
on the pad, (hardware not included).
This is a general representation of an enclosure
mounted on a pad. Configurations may vary.
12” (30 cm)
Bottom Edge of Housing
Bottom Hole
.75” (2 cm)
Top Hole
.75” (2 cm)
12” (30 cm)
Middle Hole
.75” (2 cm)
5/8” Pole
Bolt and
Square
Washe
r
Service Entrance/
Load Cente
r
Coax Housing
Meter Base
Coax Housing
Mounting Bracket
is permanently
attached to
enclosure.