Technical data

User’s and Service Guide 5-5
Controlling the Test Set and Making Measurements
Commands
Network Analyzer Control
The third method of sending commands uses the network analyzer to
control the test set directly. This method is performed with the
standard setup of the network analyzer working with the test set. A
parallel cable is connected from the network analyzer parallel output to
the test set parallel input on the rear panels of both instruments.
NOTE The following key conventions are used throughout this document.
•
[HARDKEYS] are labeled keys on the instrument front panel.
•
SOFTKEYS are unlabeled keys whose function is defined on the
instrument display.
• Information shown on the instrument display is shown LIKE THIS.
The key labels can be either upper case or lower case.
1. Press
[SEQ] > TTL IO > PARALLEL OUT ALL.
2. Use the arrow keys,
↑=or ↓=to scroll to the desired test port address,
or input the number directly using the
[D] > [x1], where D represents
the decimal value of the test port address.
Refer to Table 5-1 on page 5-6.