Technical data

User’s and Service Guide 6-3
Servicing the Test Set
Performance Testing
There are no adjustments required for the Agilent 87050A Option H15
test set.
Set up the network analyzer using the following procedure.
Step 1. Set the number of points to 401 by pressing:
[MENU] > NUMBER OF POINTS > [401]
Step 2. Set the IF Bandwidth to 10 Hz by pressing:
[AVG] > IF > BW > [10] > [x1]
Step 3. Connect the test port cables to Port 1 and Port 2 on the network
analyzer.
Step 4. Connect the parallel port connector from the network analyzer to the
test set.
Step 5. Set the parallel port to “GPIO” by pressing:
[LOCAL] > PARALLEL > GPIO
Step 6. Set the network analyzer to utilize internal memory by pressing:
[SAVE/RECALL] > SELECT DISK > INTERNAL DISK