User`s guide

52InRow RD 100-Series and InRow RD 200-Series User’s Guide
APC Device IP Configuration Wizard
Capabilities, Requirements, and Installation
How to use the Wizard to configure TCP/IP settings
The APC Device IP Configuration Wizard configures the IP address, subnet mask, and default gateway
of one or more InRow RDs. You can use the Wizard in either of the following ways:
• Remotely over your TCP/IP network to discover and configure unconfigured InRow RDs on the
same network segment as the computer running the Wizard.
• Through a direct connection from a serial port of your computer to the InRow RD to configure or
reconfigure it.
System requirements
The Wizard runs on Microsoft Windows 2000, Windows 2003, and Windows XP operating systems.
Installation
To install the Wizard from the Utility CD:
1. If autorun is enabled, the user interface of the CD starts when you insert the CD. Otherwise, open
the file contents.htm on the CD.
2. Click Device IP Configuration Wizard and follow the instructions.
To install the Wizard from a downloaded executable file:
1. Go to www.apc/tools/download.
2. Download the Device IP Configuration Wizard.
3. Run the executable file in the folder to which you downloaded it.