User`s guide

InRow RD 100-Series and InRow RD 200-Series User’s Guide53
Use the Wizard
Note: Most software firewalls must be temporarily disabled for the Wizard to discover
unconfigured InRow RDs.
Launch the Wizard
The installation creates a shortcut link in the Start menu to launch the Wizard.
Configure the basic TCP/IP settings remotely
Prepare to configure the settings. Before you run the Wizard:
1. Contact your network administrator to obtain valid TCP/IP settings.
2. If you are configuring multiple unconfigured InRow RDs, obtain the MAC address of each one to
identify it when the Wizard discovers it. (The Wizard displays the MAC address on the screen on
which you then enter the TCP/IP settings.)
– The MAC address is on a label on the InRow RD.
– You can also obtain the MAC address from the Quality Assurance slip that came with the
InRow RD.
Run the Wizard to perform the configuration. To discover and configure unconfigured InRow RDs
over the network:
1. From the Start menu, launch the Wizard. The Wizard detects the first InRow RD that is not
configured.
2. Select Remotely (over the network), and click Next >.
3. Enter the system IP, subnet mask, and default gateway for the InRow RD identified by the MAC
address. Click Next >.
On the Transmit Current Settings Remotely screen, if you select the Start a Web browser
when finished check box, the default Web browser connects to the InRow RD after the
Wizard transmits the settings.
4. Click Finish to transmit the settings. If the IP address you entered is in use on the network, the
Wizard prompts you to enter an IP address that is not in use. Enter a correct IP address, and click
Finish.
5. If the Wizard finds another unconfigured InRow RD, it displays the screen to enter TCP/IP
settings. Repeat this procedure beginning at step 3, or to skip the InRow RD whose MAC address
is currently displayed, click Cancel.