Datasheet

2-9
displayed. APC recommends you set the “default” screen showing the
“ ESTIMATED RUNTIME and FUEL ” display (Figure 13).
Informational Screens
The J10 and J15 Power Conditioners with Battery Backup provide the following
informational screens, accessed using the STATUS push button:
•
Source: XXXXXXX screen
•
FW Version: XXXXXXX screen
•
Model Number and Serial Number screen
•
Phone Number and Technical Support Internet Address screen
•
Input Frequency; Output Frequency screen
SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen
This screen, shown in Figure 14, shows which source the unit is providing power
from ( UTILITY , BATTERY, or STANDBY). It also displays the Estimated
Runtime (in hours) based on the power source and connected equipment load. In
Standby mode, the unit does not provide an output to the rear panel outlets.
Note: Whenever the J10 or J15 is connected to utility power, the electronics
inside of each unit are active. If the front panel Power Switch is turned
off, the unit goes into Standby mode and shuts off power to the
rear-panel outlets.
Figure 14. SOURCE: XXXXXXX; EST. RUNTIME: XHRS Screen