Owners manual

55KVM Access Management Software User Manual
4. Fill in the fields according to the information in the following table.
7. When finished, click Save. The Add Ports List page opens.
8. Click checkboxes to add ports into this Aggregate Device, click Save to open the Access Rights
Summary page.
9. Select which user will use this aggregate device from the drop down list and click Save. The
Ports List page opens showing which ports can be managed under this aggregate device:
Note: 1. Redundant Power settings are only enabled for Aggregate Devices if power outlets
have been added to the device.
2. The Properties, Connectivity, and Access Rights Panel Menus bring up pages that offer the
same fields as the ones encountered when the Aggregate Device was created. Use them to
change any of the device's settings information.
3. Any ports listed on the page can be combined in the Aggregate Device. Put a check in the
checkbox in front of the ports that you want, then click Save.
4. If a port is already part of another aggregate or group device, a dialog box appears to notify
you that it will be removed from the original device when added to this aggregate device and
asks you to confirm that this is what you want to do. Click OK to accept the change or
Cancel to abort.
Field Explanation
Network
Information
Select the network: If the server for the aggregate device only has one network interface,
select Primary, then configure the remaining fields. If it has more than one network
interface, after you finish configuring the Primary network interface, come back to choose
the additional network interfaces and configure each of them in turn.
Name: For convenience, each of the network interfaces can be given a name.
IP Address: Select the KVM ACCESS unit to which the Aggregate Device server is
connected.
Web Session IP address, Login name, Password, SSH port: To access the Aggregate Device server via
an SSH session, enter the appropriate information into these fields according to the
Aggregate Device server's authentication and authorization procedures.
Telnet Settings To access the Aggregate Device server via a Telnet session, enter the information into the
fields according to the Aggregate Device server's authentication and authorization
procedures.