User`s manual

5
4.3 Connect the power conditioner to service and enable
■ 120 Vac version
Plug the power conditioner into a two-pole, three-wire grounding recep-
tacle only. Avoid using extension cords and adapter plugs.
■ 230 Vac version
The 230 Vac version of the power conditioner is supplied with two output
IEC 320 cords. Swap a line cord from your equipment with one of the
output cords and plug in the power conditioner using the equipment cord.
The power conditioner’s input cord must be three-conductor, each 1.0
mm
2
, rated to 10 Amps.
If your equipment does not have a removable line cord, a rewireable plug
(included) may be installed on the line cord. Additional output cords and
adapter plugs are available from your dealer and from the factory.
4.0 Installation